Had a busy week this week when I got my car I had a tonneau cover that fits over the roof I tried it when I was building the car and it wouldn't fit because of the rear bulkhead. So I thought I'd have a go at making it fit so I got a piece of ply and fitted a few blocks to the ply about the same measurements then took the cover and a steamer and started to steam and bend a little bit at a time just take it steady. It looks ok the only problem the little pigs that stick up near the doors I had to unscrew and packed them up with two small washers and a spring washer in between to make them that little bit higher. I'm not sure when two die it Black or red but not might not get the same red as the seats or could leave it as it is, what do you guys think.